|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SHOE (SHOWN) AT PAVED SURFACES OR SPLASH OR PLASTiC GUARD CAP (NOT SHOWN)
AT CONNECTiON TO DRAiN PiPE
SPLASH BLOCK AT LOCATiONS WHERE DOWNSPOUT iS NOT CONNECTED TO DRAiN PiPE. BEFORE RELYiNG ON A SPLASH BLOCK, VERiFY LACK OF NEED TO CARRY WATER TO STORM SEWER OR DRY WELL.
 |
OGEE iS THE MOST COMMON GUTTER SHAPE. AVAiLABLE iN SiTE-FORMED ALUMiNUM Or GALVANiZED iN A VARiETY OF SizES, iT iS Also Made iN unpAINTED GALVANizED STEEL OR cOppER.
wOODEN GuTTERS ARE used extensively IN THE NORTHEAST. THEY ARE DiFFicuLT TO JOIN AT cORNERS OR FOR LONG LENGTHS & ARE pRONE
to decay.
concealed gutters OF
VARIABLE SHApES & SizES MAY BE DESIGNED TO FIT BEHIND THE FASciA OR wiTHiN THE SLOpE OF A ROOF. THESE ARE ALwAYS cuSTOM MADE & ARE THEREFORE ExpENSIVE. upper edge of gutter is typically lapped by
ROOFING; LOwER EDGE
caps fascia.
bracket hangers are
AVAiLABLE FOR ALL TYpES OF GuTTER; ScREw TO FASciA OR (wiTH LONGER ScREwS) TO RAFTER TAILS.
spike & ferrule HANGERS ARE used with BEVELED OR OGEE gutters; spike TO fascia OR
TO RAFTER TAILS. THE NEED FOR expansion joints IS GREATEST with this type of connector (maximum run without JOINT IS 40 FT.).
strap hangers are used with
METAL HALF-ROuND GuTTERS; NAIL OR ScREw TO ROOF SHEATHING OR THROuGH SHEATHING TO TOp OF RAFTER.
uncommon, archaic.
NOTES
FASCIA IS SHOWN PLUMB FOR EASE OF INSTALLATION OF COMMON GUTTERS.
SQUARE-CUT RAFTER TAILS WORK WHERE THERE ARE NO GUTTERS OR WHERE HALF-ROUND GUTTERS ARE HUNG FROM STRAP HANGERS.
SEE 195C
FASCIA IS GENERALLY 2X MATERIAL FOR EASE OF INSTALLATION OF COMMON GUTTERS.
IN SOME AREAS. THE 2X IS USED AS A SUB-FASCIA AND COVERED WITH A HIGHER GRADE 1X FASCIA. GUTTERS MAY BE HUNG FROM A SINGLE — IX FASCIA. BUT SPIKES MUST BE LOCATED AT RAFTERS & FASCIA PREDRILLED TO PREVENT SPLITTING. BRACKETS SHOULD BE LOCATED NEAR RAFTERS.
